exrider272
07-20-2009, 08:53 PM
ok well couple weeks ago i sent my cylinder out to GT thunder to get HD head studs put in.. and didnt get it put my motor all back together till tonight.. well while i was at it i figured i would install new rings and valve seals.. well i got it all back together and started it and it just started rolling out smoke.i figured it was just alil bit of oil in there burnin out so i let it run for about 10min and it was still smoking.. so i figured i fergot to stager the rings on the piston.. so i riped it all back apart and the 2 top rings were alined.and there was oil all over the piston and cylinder so it was gettin oil by pass into the cylinder.. so i stagerd them as the clymers manual said this time.. and put it all back together and started it up and no smoke.. so i hoped on it and took it about a mile down the trail look back and all u c is smoke.. i no the rings are correct.. and its doing the exact same thing as when it was gettin oil by pass threw the cylinder.. i have no clue wat it could be doing and wat is causeing it. and i dont think the rings could move while inside the cylinder...
anybody ever have this happen before? or no sumthing ?
anybody ever have this happen before? or no sumthing ?