snapped bolt

[400exrider139]

i snapped a bolt puttin on my clutch case cover an was wonderin if there was any way to get the bolt out without removing the case again?

[250x_kyle]

u could possibly use easy outs depending on how flush with the case it broke. however i would remove the case to be sure there is no debris in there. and get a torque wrench on that bad boy so that dont happen again.

[kitman]

id just take the time to drain the case and take the cover off again , then if there is enof sticking out you could grab it with vise grips or if you have a air grinder you could grind a little grove in the end and try with a flat head screwdriver

[400exrider139]

would it be ok to ride without this one bolt?

[kitman]

well if its not leaking oil sure, but i wouldnt forget about it