eton 70 motor in drr 50 frame`

[vindell]

will this work, look's goog.

[dblacks]

same motor

[ecmini1]

Sure will.

[vindell]

how bout the wiring harness, must I remove all electrical connection and install on drr from eton. or will they match up?
Is it a good Idea to remove plastics, or not . or Should I just put koso 70 head on the drr 50, install koso intake, and keihnin 20 on the new 50 motor. and not even remove engine and electrical.
Please advise. by the way what a diff from the eton chassis, took for a spin last night with my youngest, Mikey, the chassis is alot more comfortable. Love the 40inch width over the 33inch the eton has

[dblacks]

I am not familiar with the Eton wiring but it must be the same plug of te stator thus it would match up.

Cylinder, head and piston will all go on the drr motor along with clutching

[vindell]

This is the way I will probly go, a whole lot easier. Need some opinions here. Swap motors or swap parts.

[ecmini1]

The harness for the most part is the same it will have it diffrences. But for a engine swap its going to plug right up. pump Now you can start to build you a back up engine to swap at later date.

[vindell]

how long should a swap take, handy with tools, approximate.

[ecmini1]

Never doing it before Couple of hours.

[vindell]

how bout swapping jug,card,intake,carb and leaving engine in the drr. which way should I go