98_330ex
07-10-2009, 04:06 PM
HI
I AM LOOKING FOR A 250X BOTTOM END OR A 300EX BOTTOM END
I FOUND A CHEAP 250X AND BOUGHT IT DIDNT RUN SO I TORE IN TO IT TIMING HAIN WAS OFF SO I WENT DEEPER TO FIGURE OUT WHY AND THE PISTON WALL IS SCUFFED HARD WITH LITTLE PEICES OF THE PISTON MELTED TO THE WALL THE OIL DRAIN PLUG DONT HAVE ANY TREADS LET ON IT SO I AM NEEDING A BOTTOM END AND THE ROD BEARINGS ARE GONE I CAN MOVE IT 1 1/2 BOTH WAYS THANKS FOR YOUR HELP IN ADVANCE
I AM LOOKING FOR A 250X BOTTOM END OR A 300EX BOTTOM END
I FOUND A CHEAP 250X AND BOUGHT IT DIDNT RUN SO I TORE IN TO IT TIMING HAIN WAS OFF SO I WENT DEEPER TO FIGURE OUT WHY AND THE PISTON WALL IS SCUFFED HARD WITH LITTLE PEICES OF THE PISTON MELTED TO THE WALL THE OIL DRAIN PLUG DONT HAVE ANY TREADS LET ON IT SO I AM NEEDING A BOTTOM END AND THE ROD BEARINGS ARE GONE I CAN MOVE IT 1 1/2 BOTH WAYS THANKS FOR YOUR HELP IN ADVANCE