About to order tires, last minute decision, advise please!

[kouki]

I'm getting ready to order some new rear tires for my R. I am leaning towards the Kenda Klaw XC. But the regular Razr is close to the same price. How do they compare for an all around tire? I don't race, just play. Mostly open fields, fairly smooth trails, jumping, etc. I'm going to be getting a 20x11x9 in either, and I have a esr 310. Will they both do the job just as well?

[zedicus00]

i run the RAZR but for your riding environment the kenda might be better. honestly iether will work pretty good for those conditions.

[89rwfo]

them razrs weigh a ton go with the kenda.

[250Renvy]

I'd go with the Kenda's. If you go with Razors the Razor 2's are the ones to get.

[danhung11]

Depends on if you get the 4-ply or 6-ply? Yes, the 6-ply razr's would weigh more but I think the "bite" is better than the klaws. I have run the 6-ply razrs and now have the klaw mxrs on the rear.

If it were me, I would buy another set of razr's.

[Honda 250r 001]

i vote klaws

[rigger]

I just ordered a full set of 6 ply Claws for my project R and my Wife's 400EX. They are not heavy like I thought they would be. Only got a short little ride on them with the 400 and I was pretty impressed with them. Front would grab really well. The rear broke when I wanted them to and grab when I wanted them to as well. Got into a little deep water and mud hole and they pulled right through it with no hint of traction loss.

That was only one little short 10 minute play ride though. And I am sure they will act different on the R but I like them a lot so far.

[rustyATV]

I've not tried the Kenda rears (just the fronts), but I raced the Razr's a few times. I liked them until the tread got a little wear, then they wouldn't hook up quite the same. I usually use Holeshots now, but I might try the Klaws in the near future.

[JM317]

As far as Kenda, I like the Knarly XC's but they're 21X11X9 and also a 6ply. You can get them in a bias ply or radial.