Need exhaust help

[dylandrew1]

I’m looking for an aftermarket header to go with my Motoworks slip on. I can’t find one anywhere. The FMF Powerbomb will fit the bike, but I can’t get any guarantees from FMF or Motoworks that it will fit the slip on. Do I need to start over and buy a full set up? I added some goodies and want to take full advantage of the power (440BB, Hotcams, P&P to go with my FCR and no airbox setup). Any suggestions? If I have to bite the bullet and buy one, what’s the best value? I ride primarily in the desert and on trails.

[cataway]

i have one for a yoshi , shoot me an offer

[dylandrew1]

Can you send photos? Will this fit a Motoworks? PM or email directly if needed. dylandrew1@verizon.net

[cataway]

i would say you have to ask Motoworks that one.
you want pic's ,i can get that , will need 24 hr

[jonboy]

Find out the I.D. of the header and the O.D. of the slip-on that should tell you wether it'll fit or not. Even if it is the same you could just take iy to an exhaust shop and have them expand it just a bit to fit. Thats what I did to get my Yosh header to fit my FMF pipe.

[dylandrew1]

I can get the measurements of the slip-on. Cataway, can you get the header measurements? I'm more concerned with the header being too long or too short. If it's too long, I can work with it. But too short and I'm SOL! I'm actually picking the bike up from the shop Saturday, so I'll get the measurements then.

[cataway]

http://i44.photobucket.com/albums/f9/cataway/ltzstuff001.jpg

http://i44.photobucket.com/albums/f9/cataway/ltzstuff002.jpg

http://i44.photobucket.com/albums/f9/cataway/ltzstuff003.jpg

looks like 1 5/8 '' on the pipe

[dylandrew1]

Thanks for the pictures. I'll get measurements tomorrow and we'll go from there.

[dylandrew1]

The end of the Motoworks pipe is ~1.580. If the Yoshi is 1 5/8 (1.625), the difference is about .045. How tight/loose should this fit?