parts to rebuild rear shock

[sdyme1995]

First off I did search for rear shock rebuild and all i found were to send it here or send it there.

Does anyone know where to get the seals or a rebuild kit to do the rear shock.

Cause as of now it is sitting in the garage going drip, drip, drip.
thanks

[Honda 250r 001]

i think if you called derisi racing or some place like that and i would think they could get you the parts. but its pretty hard to get them i think. Its much easier to send them it, but if you have no moola, im sure you can do it.

[IcutMetl]

You can buy a upgrade "Gold Valve" valve kit and the weight matched spring ($100 range) from Race Tech (same valve kit on ebay for $159). Oil you can get from anywhere; Honda service manual actually reccomends ATF fluid. I swear I saw the seals in one of the "big" catalogs. Sure you could buy seals and bump stop from Race Tech as well.

[sdyme1995]

thanks guys,
yeah I checked the racetech site. I dont really need to go with the gold valve setup. Just needed to rebuild it. I only rec. ride trails and dunes, no racing or MX.

Still looking around for the parts though so if anyone else know where to get them let me know.
Thanks

[sdyme1995]

anyone else know of where to get the parts. All I have found is a Moose seal head.

[Honda 250r 001]

ive just always filled it till no more oil would go in. Take the bladder out of the resivore and dump oil in there and push the shock in and out slowly until all the oil goes in, dump more oil in the rezzy until its full, then fill the rezzy 3/4 of the way and put the bladder back in.

[Honda 250r 001]

i never needed anything special, to get the actual shock apart i used a pipe wrench to get the cap off and some little dentist picks to get the snap wrings out. other wise its pud.