Slipper Sprocket

[CRBOGGAN]

I noticed the beveled washer was cracked in several spots on the nut side of sprocket. I ordered a whole new assembley as to have spare parts anyway. Has this happened to anyone? And can you get just a washer? Thanks to Marc at HOTQUADS he got the new sprocket to me next day so we did not miss any ride time.

[TTracer#22]

The same thing happened to me along with broken clutch disc. I was torqueing to 110ft lbs I backed it off to 100ft lbs and have had no problems since. also the apex washer is thicker than the DRR and I think you can buy them by themselves.

Hope this helps

[CRBOGGAN]

Thanks about the apex will look in to it. I did the same on the torque but I went from 105 to 95. Most torque wrenches have a +/-5% range.

[dericsdad]

If your torque wrench is off that much then you need to get it recalibrated or buy a new better quality one!

Give it to your snap-on or matco dealer and tell him to send it in for recalibration!!

The correct torque for the DRR slipper sprocket is 105 ft lbs. I've never cracked a washer with this.