clutch is hard to pulll?

[timmy400exfast]

i just put some ebc clutch springs in and now the clutch barley pulls in do i need to break in the springs??or what

[honda400ex2003]

they may just be that hard. the plates should mesh a bit and it may make them a bit softer but for the most part they will be stiffer i think. mine are a bit but with the asv and the magura before that i never really noticed if it was too much stiffer. Do you still have the stock perch? steve

[timmy400exfast]

they just had to be broken a a lil bit but there nice and that magura i had that on may 2002 ktm 125 those things are nice

[honda400ex2003]

i liked mine too but they do not work good with the aftermarket stuff. It would not pull far enough to disengage the clutch. I would adjust it and then the plates would wear a bit more and it would get all messed up. I blew the seals in my slave cylinder while rebuilding my 400 and sold it. It worked like described above after the rebuild. I hit the lever by accident while it was off the clutch and it blew the seal out of it. All well i like the asv better and it looks cool too so it was a win win for me. steve