Relocation

[hondaracing0144]

How can i relocate the switch and the red/green light i know you can cut a whole and put it in the plastic but someone told me i need a rubber peice to put in first

[petryna]

you can relocate it no problem. the rubber is already in the light plastic you just have to pop the red and green light covers off and they are sitting in the rubber that fits in the hole.

[hondaracing0144]

even for the switch

[Grimzella]

Originally posted by hondaracing0144
even for the switch

ignition switch does not have a rubber ring.. i just cut a hole in plastics on right hand side (top). make sure you dont cut the hole too big.. you want it to 'snap' into a tight fitting hole.

[hondaracing0144]

okay thanks does it hve to b in a curtain place for Atv mx? cause i know you havve the kill switch connected to it

[hondaracing0144]

????

[IRISH-RACER-14]

Originally posted by hondaracing0144
okay thanks does it hve to b in a curtain place for Atv mx? cause i know you havve the kill switch connected to it

naa just put it at the side of the fenders...u dont even need them lights for mx

[dirtdawg]

i made a dash plate. might be bad for racing though because you could hit your face on it if you land a jump wrong (if there are any) or if you crash.