Houser A-arm assembly ?.

[nakomis0]

I'm trying to tighten the balljoint to the spindle. The balljoint just keeps spinning.

Ussually there is a notch right near the balljoint boot, where you can get a wrench. I don't see that notch on my Housers.

I might need to lift the boot up more, but I looked pretty good and didn't see it.

So how do I tighten this?

I bought these arms used, so I'm not sure if they are are old school Housers or what. They are about 1 yr old.

[Extremeracer167]

mine was the same way. But i just pushed down on the top of the hiem as ahrd as i could and it eventually cought and started tightening.:confused:

[nakomis0]

ahhh, That was pretty easy. Just tapped the top of the balljoint with a hammer a few times. No problems.