87 250x parts needed

[dman66]

Looking for rear brake resivior, gas tank mounting harware, front left nissin caliper, left side engine cover-where the forward/reverse lever is,head light assembly,rear fenders,engine gaskets............

[ppeengines]

I have a head light for a 87 250x but it came off of a 91/92 its blue, and a whole gas tank off of a 87 with petcock on my extra parts shelves that needs to be getting rid of. What mounting hardware do you need? Make me an offer, any offers will be considered. They need a home. Have parts for:
88 to2006 Banshee parts
89 250r parts
atc250r
2001 cr500
97-99 cr250
08 hayabusa
all years 250x
some 450r
04 to 05 zx-10 ninja parts
z400 parts
400ex rolling chassis's and swingarms almost can build a whole another 400ex minus a few minor parts
There is more but i think you get the hint. I have a little of everything accumulated over the years. Shelves need to be cleaned off to put more parts on them. If you need any thing else for your 250x there is a good chance I may have it for real cheap.

[josh79z28]

do you have a good cdi box ? if so how much

[ppeengines]

Originally posted by josh79z28
do you have a good cdi box ? if so how much

Let me get to the shop tomorrow and I will look. I think I do but not sure. But here is what i know i have for sure. 250x parts
1. carburetor with a cable( cable is in so so condition but works)
2. gas tank good condition with petcock and gas cap.
3. clutch lever with perch/parking brake lever
4. head light with kill switch( no cut or spliced wires) but plastic outside of it is scuffed up. with bracket to mount it up
5. foot peg( not sure what side)
6. cylinder that needs to be resleeved
7. handle bars aftermarket aluminum ones have no clue what the brand is but straight
8. axle lock nut
9. coil but plug cap looks to be needing replaced.
10. cylinder but it needs to be resleeved( has piston stuck in it with a snapped connecting rod attached.
11. voltage regulator
12. steering stem mount( the clamp where you clamp your stem up top to the frame with bolts
13. very good front and rear sprockets like new, rear is a 38tooth and sprocket mount bolts, have a chain too but is a little rusty but was almost new when the quad was brought to me.
14. OEM front rims and Othusus h-trak front tires w/50% tread and rims have some scuffs but no dents and are straight.
15. air box boot from the carb to the airbox.

This was an 87 250x but should fit all years 250x and some 300ex, but check first for the 300exthe parts came off of. The quad was brought to me blown up and the customer didnt have the money to rebuild so i bought the quad to part up and these are the remaining parts i have left. Make some offers, and I will get back to you.

[dman66]

Any working brake calipers or p-brake cable? How much for head light? Any pics? Crankcase cover still around- the one on left foot side?