250R a-arms?

[kouki]

Hey, I just bought this R a couple weeks ago. I wasn't sure what the arms were so I made a post on here. People are saying that they are from you guys, and just wanted to see if you could confirm that. Do you make stock length because these seem pretty close to stock lenght. Do you have measurements from end to end of upper and lower arms so I can figure out the size as I want to go wider but need to know how far I am really going. Here is a link to the post with pics of the arms on my 250r.
http://www.exriders.com/vbb/showthread.php?s=&threadid=396876

[burgard rep]

As far as I can tell they are ours. They are most likely a plus two. Does it have an axle on it? If it doesn't is the front wider than the back?

[kouki]

I'm pretty sure that the rear axle is stock. The front and rear seem pretty even. Do you happen to have any measurements from end to end of the upper or lower arms so I can confirm the length. Here is a pic of the front of my quad so you can see the stance. It is sitting a hair high in this pic because there is no motor in it.

http://i4.photobucket.com/albums/y135/super_rad_1000/IMG_1270.jpg

[burgard rep]

I'll get a measurement for you by then end of the week.

[burgard rep]

stand the quad on the grab bar and measure the bottom aarm from the back of the ball joint mount to the center of the shock mount and you should have a bout 5 inches if its a +2. here is a pic to help you out.
http://i416.photobucket.com/albums/pp242/burgardrep/CIMG3170.jpg