Hole in case by primary sprocket.

[Micahdogg]

I have a 87 250x with a chunk of the case gone by the primary sprocket....which appears to be pretty common on these quads. I was thinking of taking the case off and preping it really well for a JB weld patch job, but then I remembered using a kit to seal up a crack in a gas tank. This kit had a JB weld type goo and also some fiberglass cloth. When it dried that sucker was tough. I'm just wondering if maybe this wouldn't work better on a hole in the case instead of just filling it in with pure JB weld.

Any ideas? I can't afford to go have it welded up.....I am maxxed out on mods to this quad and need some DIY advice.

Micah

[redrider ex]

That will work i have done it before but you will have to get it as clean as you can and have the area being fixed oil free or it will not work.

Yes jb will work my buddy did it to his about 3 times.

[DaveEX7]

make sure its absolutely clean..... like red rider said =)

[Micahdogg]

Yes jb will work my buddy did it to his about 3 times.

Ha, sorry, but does anyone else see the humor.

Micah