infrontofu
05-16-2009, 01:43 PM
88r decent atv
new motor new piston 040 bore new gaskets and seals crank looked good as well as rod bearings ct mx porting hits hard in the middle.
lrd pipe and silincer
protaper bars
old skool curtis sparks seat cover
front holeshot mx 90$
rear turf tamers grooved on baja wheels tires are new
new front brakes and wheel bearings
new coil
frame has no cracks welds or repairs
engine cases has no welds cracks or repairs
motion pro twist throttle
new 2 weeks ago did o ring chain
maier plastic front is great rear is scraped up from looping it
starts first kick almost every time runs great motor has less than 1 hour on rebuild and buyer is welcome to pull head before purchase as long as you replace the cr head gasket even if you dont buy it.
clutch was replaced at time of rebuild as well.
stock shocks and a arms on it ball joints are tight
i have a bearing kit for the whole atv but it dose not need any replaced it is tight as is.
needs front bumper one on it does not fit it correctly rear grab bar had 6 pack rack i put it on my outher atv was gone put stock back on but cant find it i will if i do.and seat latch was broken as well i bought one off e bay just waiting on it to get here.
1800$$$$ or i will trade it for a popup camper.
pm for contact info
new motor new piston 040 bore new gaskets and seals crank looked good as well as rod bearings ct mx porting hits hard in the middle.
lrd pipe and silincer
protaper bars
old skool curtis sparks seat cover
front holeshot mx 90$
rear turf tamers grooved on baja wheels tires are new
new front brakes and wheel bearings
new coil
frame has no cracks welds or repairs
engine cases has no welds cracks or repairs
motion pro twist throttle
new 2 weeks ago did o ring chain
maier plastic front is great rear is scraped up from looping it
starts first kick almost every time runs great motor has less than 1 hour on rebuild and buyer is welcome to pull head before purchase as long as you replace the cr head gasket even if you dont buy it.
clutch was replaced at time of rebuild as well.
stock shocks and a arms on it ball joints are tight
i have a bearing kit for the whole atv but it dose not need any replaced it is tight as is.
needs front bumper one on it does not fit it correctly rear grab bar had 6 pack rack i put it on my outher atv was gone put stock back on but cant find it i will if i do.and seat latch was broken as well i bought one off e bay just waiting on it to get here.
1800$$$$ or i will trade it for a popup camper.
pm for contact info