help, did the sparks key and i have an extra part...

[uchi]

i changed the key tonite. piece of cake except for the fact that i had to buy a 30 mm socket. all in all its a 20 minute job. so as i was putting things away i was making sure i got all my tools picked up and i found this ring. not sure where the hell it goes. i didnt see it fall off anywhere, maybe soneone can help so i can get it on tomorrow morning and test the new setup out.

here are the pics

http://img.photobucket.com/albums/v96/turbocav/atv/IMG00343-20090515-2116.jpg

http://img.photobucket.com/albums/v96/turbocav/atv/IMG00344-20090515-2116.jpg

http://img.photobucket.com/albums/v96/turbocav/atv/IMG00345-20090515-2116.jpg

[uchi]

i also noticed the neutral switch wire doesnt wanna stay on the tab on the motor, any tips for getting that back on? adn what happens if i leave it off?

[ZSK]

Washer under the bolt that holds the flywheel on? A little solder should help hold it on, if you don't put it on your neutral light won't work.

[uchi]

i just managed to find a pic in the serivce manual, looks like its thr ring that the flywheel sits on. just my luck, lol. oh well, itll get done tomorrow or tonite if im feeling saucy and cant sleep :)

[bean2080]

im not sure about the extra part but for the netural wire, take it off the tab and crimp the end of the wire just a little bit to make it fit on snug again, thats that i had to do. if you take it off, nothing will go wrong, you just wont have a netural light. i just put a new one on mine and before that there wasnt one on it for a while.

[Snipe]

all it will do is when you go in nuetral your light wont turn on on your dash. It dont matter I un hooked my reverse light so I can start mine while its in reverse.

As for that it is a seal of some kind prob goes on the shaft. Like a push on style seal.

[thebig450es]

Yeah just pull the flywheel off and slide the 30mm washer on and button it all back up