how to install a teather killswitch?!

[300exrider26]

can someone post how to installl a teather killswtich? thanks

[RideRaceLive93]

this is how i do them for the pro armors

1st.) locate the coil that is closest to the spark plug there is another one on the back of the bike near the battery DO NOT USE THAT ONE(there black)

2.) there is two wires that are seperated going into it unplug them and pick one (i used black ive got an 06)

3.)strip the covering of (i used a razor balde Dont cut the connection for the prong off)

4.) if it for a pro armor take the long wire of the kill switch and strip it now make two diffrent ends with the copper wire

5.) twist the ends around the wire for the coil that you stripped

6.) the short wire is your ground,strip that and get a connection that looks sorta like O== i quess you could say, now find a bolt hole on your frame, sand it down so there no paint and the put your ground in

7.) test it

8.) Shrink and electric tape it back up plug every thing back together

9.) go ride and be safe