atvnut07
05-06-2009, 11:19 AM
I need to know if there is a shaft for the kickstart 2nd idler gear or if the gear is kept in place by the gears it meshes with? I'm building an 87 trx250x lower end from scratch using the clymer<:mad: manual.
In the manual it says to install the 2nd idler gear bushing on the shaft and then install the 2nd idler gear onto bushing, but the diagram does not show a shaft for the 2nd idler gear and there is no listing for a 2nd idler gear shaft on the parts sites. AND i have no shaft for that gear in my box of parts.
I am stuck right here until I get an answer back from clymer or one of you engine gurus out there.
Any help will be highly appreciated.
Thanks in advance! atvnut07
In the manual it says to install the 2nd idler gear bushing on the shaft and then install the 2nd idler gear onto bushing, but the diagram does not show a shaft for the 2nd idler gear and there is no listing for a 2nd idler gear shaft on the parts sites. AND i have no shaft for that gear in my box of parts.
I am stuck right here until I get an answer back from clymer or one of you engine gurus out there.
Any help will be highly appreciated.
Thanks in advance! atvnut07