250R LoneStar Axle Issue

[Ruf Racing]

250R Lonestar Axle, why is the left side (sprocket hub) not over
enough? What is keeping it from pressing further on? Is there a
clip on the inside stopping the hub? Because of this, the bearing
race is half way sitting in the that groove, effecting the right side
not having enough surface area for the bearing. Any suggestions?
Thanks. :confused:

http://i532.photobucket.com/albums/ee328/RideRed187/ATV%20Parts/006.jpg

[Honda 250r 001]

pull the hub off and see. that is a defeneatly a problem though, mine is not like that. Flaw in the teeth maybe?

[deathman53]

I can see a groove for the c-clip, maybe you lost the c-clip. Bring it to a machine shop, press the hub down and you should see a groove where the c-clip goes. It will be inside the spline on the axle.

[Ruf Racing]

Thanks Guys, I'll remove the hub. :cool:

[Ruf Racing]

There was no c-clip install on the sprocket hub. Installed one,
good to go. Thanks for the help. :D :D :D :D