IcutMetl
04-22-2009, 07:16 PM
Just trying to get a baseline as far as jetting; at least for break in.
Previous setup:
.020" wiseco piston, stock cylinder, no porting, P.T. Hi-Rev Pipe, no airbox, K&N with outerwears. 50:1 golden spectro on pump gas, 38mm PJ; not sure about the needle, but the main is a 160. Started easy, warmed up and ran out good. Never fouled a plug, and the plug was clean with no major buildup. Very little smoke.
Soon to be:
.060" wiseco piston, stock cylinder, midrange portig, FMF Fatty pipe, airbox with vented or no lid (havent decided), 40:1 Klotz Super Techniplate on pump gas; same 38mm PJ. I wouldn't mind breaking it in rich, but what jets should I buy to trim it in with?
Thanks for the help guys!
Previous setup:
.020" wiseco piston, stock cylinder, no porting, P.T. Hi-Rev Pipe, no airbox, K&N with outerwears. 50:1 golden spectro on pump gas, 38mm PJ; not sure about the needle, but the main is a 160. Started easy, warmed up and ran out good. Never fouled a plug, and the plug was clean with no major buildup. Very little smoke.
Soon to be:
.060" wiseco piston, stock cylinder, midrange portig, FMF Fatty pipe, airbox with vented or no lid (havent decided), 40:1 Klotz Super Techniplate on pump gas; same 38mm PJ. I wouldn't mind breaking it in rich, but what jets should I buy to trim it in with?
Thanks for the help guys!