Clutch bell nut

[dwhst9]

Where can I get a new nut for the clutch bell?

[dericsdad]

Polaris

[bulldogfallon]

We stock them if your local dealer have them

[dwhst9]

What tpi & pitch are the threads? I can probably find some at our local hardware store.

[etondaddy]

I have one in the trailer.



Mike Kozura

[bulldogfallon]

They are also a particular thickness...But from a shop to make sure it has the proper clearance....

The Polaris should have them

[etondaddy]

I'll post a pic of the E-Ton one tonight and we'll see if it will work.



Mike Kozura

[etondaddy]

Will this work............

Mike Kozura

http://i58.photobucket.com/albums/g278/etondaddy/102_2583.jpg

http://i58.photobucket.com/albums/g278/etondaddy/102_2584.jpg

http://i58.photobucket.com/albums/g278/etondaddy/102_2585.jpg

http://i58.photobucket.com/albums/g278/etondaddy/102_2586.jpg

http://i58.photobucket.com/albums/g278/etondaddy/102_2587.jpg

[dwhst9]

It should work. I'll put a mic on the stock nut and see what the thickness is tonight and post it.

[dwhst9]

The stock Polaris nut is 6.15mm thick. The hole in the nut is 9.55mm, but there are no threads left (aka smooth inside now).

There is an o-ring that goes on after the nut is installed.

[etondaddy]

I'll send it out tomorrow it'll work. Thats going to put the o-ring 2mm closer to the cover it should be ok.


Mike Kozura

[dwhst9]

Originally posted by etondaddy
I'll send it out tomorrow it'll work. Thats going to put the o-ring 2mm closer to the cover it should be ok.


Mike Kozura

Yup, plus I doubt these quads are built within 2mm tolerances :p