Help w/ CR High bars, please...

[BEAVER.989]

I just installed a set of Pro Taper Contour bars and a TrailTech clamp and am having a little trouble making everything fit... especially on the throttle side. What should I do? I'm tempted to cut the inside lip of thje grips off to make a little more room, unless someone has a better suggestion...

[BEAVER.989]

C'mon guys, I could use some help here... Has anyone trimmed the throttle housing? Theres a little piece there that sticks out and is getting in the way of the front brake handle. It's either trim the grips, or this piece, as far as I can tell...

[tjsreptiles]

i got some red cr high bend pro taper bars they fit great did nothing to then
on the throttle i cut the inside out to open the carb but i run difrent carb than stock
i not sure why yours dont fit i cut the grip then go from there

[Jdub400ex]

ya i have the pro taper contours also and everything fit fine. i did have to cut that little piece on the thumb throttle but that was to fit my power mads. you should have plenty of room.

[BEAVER.989]

Everything fits, but it seems like the front brake is all the way over where the first bend is. This is causing that lever to sit at a slight angle. You probably wouldn't notice it if you weren't looking for it, though. I guess I'll just run it for a bit and see if it bothers me.

[Pipeless416]

if you're talking about the little tab on the throttle housing, cut it off.

[rinaldi]

I have a different bar setup but had a similar fitting issue. I did the above and cut the tab off the throttle part. Easy, quick and it fixed the problem.

[BEAVER.989]

Yeah, that little tab is the part I'm talking about. I'll probably cut it off tomorrow. Thanks guys.