Pro Armor kill switch?

[DMAXX99]

How hard is the pro armor kill switch to install? I know they make a wiring kit but i couldnt find one for a 400...

[matt1106]

I think its pretty simple. there's a few ways you can do it. i think the easiest way is to hook it up to your coil

[Sanddraging28]

i wire mine into the key switch...

[bigredisb]

I took one of the wires from the tether to the black and whit wire from the factory kill switch and soldered it in and shrink wrapped it. I then took the other end of the tether and put a ring terminal on it and ran any frame mounted bolt to it. Works great and real clean looking.

[rob_990]

http://atv.off-road.com/atv/article/articleDetail.jsp?id=192238

[bigredisb]

Thats a pretty good article. The only thing I would do different is to solder and seal all connections. Quick connect electrical stuff = headaches and butchered harnesses. I have seen to many guys get a machine wet and poooff engine dies until the machine dries out.

[DMAXX99]

Well i just remembered that the killswitch on my bike is broke off...is there any way i could wire the tether to the kill switch and no longer use the killswitch?

[racerdan24]

Just installed mine on Friday and works great. No need for the harness.

[bigredisb]

If it's a normally open switch (pro armor is) all you really have to do is disconnect the ground path so that the switch has no effect when closed.

[bigd's ex]

This might help.
http://www.exriders.com/vbb/showthread.php?s=&threadid=387844

[barton1398]

If you race mx the pro armor switch will cost you or it did me twice the cord gets wraped with the big a** ears on the switch it self an gets pulled out i took mine off and chunked it an put a pro design back on it but to ansewer your question mine is hooked to the coil.