t pin for trade for llsr dc-4's

[800screws]

possibly looking to trade my +3 +1 laeger t pins for a set of lonestar dc-4 long travels and spindles for a 250r.... PM or post if u are interested. everything is tight.

[deathman53]

stem, tie-rods and ends included also? You know that the stem, tie-rods and ends aren't the same design as stock? Are they 400ex caliper or 250r caliper spindles? You setup uses 89 hubs, right?

[800screws]

everything is included except stem....the spindles i think use 400ex brakes, because the 250r brakes on there now have those billet adapters.

[deathman53]

can you do it with a trade of a laeger 250r stem. If you didn't know, the system isn't any good without the stem. The 250r t-pin stem is different than stock(or replacement), some models will work with the stock(replacement) stem, most won't.

[800screws]

this one works with a stock stem...i have a burgards +1 on it now.