400ex jug

[gregfire]

Have removed all the bolts any trick to removing the jug with out breaking any fins

[pickin_aggie08]

use a rubber mallet very carefully!! To get mine off, all it took was 5 or 6 light hits, and it came loose.

[Sanddraging28]

try a 10 pound sledge!!!:devil: :devil: lol JK

make sure you remove the two 8mm bolts on the right side of the jug at the bottom before you start trying to remove it.

as you take the jug off make sure you keep track of the two dowel pins that are on the bottom of the jug. don't let them fall into the motor...

[honda400ex2003]

There is also some under the cam down inside that may be holding it in. I had that happen to me when I did mine. They were in a bit of oil and hard to see. Good luck getting it off otherwise. you could try to tap it with a mallot and spin it a bit. steve

[gregfire]

Thanks for all the help got it lose.

[honda400ex2003]

No prob, steve