400exracer511
04-07-2009, 10:27 PM
I rebuilt my 2000 ex about 4 years ago. I bored it out to 416 and put in a JE piston and the head gasket now needs replaced.
There is a little oil leaking out the side... Is it likely that the head is warped or do I just have a bad gasket?
I no longer race so I want to spend as little as possible. I am planning on just pulling the head off and putting in a new gasket. If I decide to put new rings on, do I need to have the cylinder honed?
Are you all still using flexsteel gaskets or is there something better on the market now?
Thanks.
There is a little oil leaking out the side... Is it likely that the head is warped or do I just have a bad gasket?
I no longer race so I want to spend as little as possible. I am planning on just pulling the head off and putting in a new gasket. If I decide to put new rings on, do I need to have the cylinder honed?
Are you all still using flexsteel gaskets or is there something better on the market now?
Thanks.