View Full Version : crack case
45 lt80
04-03-2009, 09:52 PM
I have a case that is cracked on the chain side of the motor. THat is not very big about 3 inches top to bottom. What should I do get it welded or replaced it. Jack where can i get the tap to support the cases. I knew that this was going to happen because my son love jumping the lt. :confused: :confused: :mad:
I'd weld it.
To support the cases, I use 1"x1/4" aluminum. 3 pieces.
1- 3-1/2" long
1- 2-1/2" long
1-6" long
The 3-1/2 piece gets bent to fit the cases where you broke yours. Looks sorta like \__/. LOL
The 2-1/2 piece gets welded across the rear of the housing above the top hole.
the 6" piece butts up against the 2-1/2 piece and runs up toward the front.
Hope that helps. :)
45 lt80
04-10-2009, 09:14 PM
thank you LT80 i might giving u a call
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.