my 08 450

[swopesy]

bought brand new 3 weeks ago, so far added rath nerfs, renthal 7/8 bars, powermadds, killswitch, honda throttle, rear dwt wheels, and the yosh



http://i182.photobucket.com/albums/x259/swopesy/0328091454.jpg

http://i182.photobucket.com/albums/x259/swopesy/0328091454a.jpg

http://i182.photobucket.com/albums/x259/swopesy/0402091800.jpg

[geiber]

rath nerfs all the way but for the handguards, did you just put the honda one on their to get them to fit or what? because im in a little predicamin.

[swopesy]

ya rath are the best imo, i would've like to get monster pegs but there out atleast 4 weeks, and do you mean the honda throttle so the handguards would fit? i put the throttle on there cause i dont care for the big goofy plastic factory one they stick on there, i put the handguards on after the honda throttle and they fit tight and my reverse wont work cause the handguard mount stops it, im sure with a little thinking and moving around i could get it right, but as for what i think your asking im not sure how the handguards will mount with stock throttle considering its much larger, i know its tight with the honda throttle which is smaller, but im sure some way you can get them to fit right with the stock throttle..hope this helps--Steve

[geiber]

yea you've answered my question thanks, id sure like to know what the reason was for that big freakin plastic throttle case thinger, ill have to take a look at doing something like you did with a different throttle thanks.

[geiber]

you should get raths widening hubs for the back, increases the rears width 3" damn nice, although what are the rear lug patterns stock on a outlaw not sure on that but they only come in 4/110 which is awesome for me since that's the same as my honda.

[swopesy]

ya stock rear pattern is 4/110 and stock front is 4/156 i have a 450r as well so it is nice, i plan on getting a front rath hub set so i can run my honda wheels on the front as well :)