ae13291
04-01-2009, 09:32 PM
hey guys, i am currently working on my rear carrier, i am going to put a zerk fitting in the middle of the carrier and i decided since i cant put the zerk on the side like some carriers i should put a little hole in the swingarm top of the round part about the size of a 10mm socket hole, so that i will be able to grease the carrier bearings any time i want without removing the axle. but then i realized i might get stress cracks around the area of the hole? what do you guys think? also we were able to make a special tool that makes removing rear stock bearings in less then 5 minutes. if u guys want to see a picture i would be glad to show you guys.