Help---- ds450mx

[ml450r]

I need to know what this plug goes to..:rolleyes:

[ml450r]

I put everything back together and there is nowhere to plug this into...that I can find. I don't remember it not being plugged in. It has to be right in that area, it is only about 6 inche slong.

[TNT]

its the factory plug for BUDDS. Make that three cigars. :D

[dblbkb]

That plug is not for BUDDS, BUDDS is the square plug in the middle that is plugged into a blank.

The conector you are pointing out is not conected to anything. It is just tie wrapped to the side on my bike and every other I have seen.

Not sure what it is intended for only the electrical engineer knows that I guess. Perhaps it is there to add weight! :ermm: :confused: :blah:

[crixal]

rossier already sent your motor back?

[ml450r]

Originally posted by crixal
rossier already sent your motor back?

Yes, just fired it up, still waiting on rear shock, it wil be here tomorrow.

Thanks for the help guys. I figured it would go to nothing. I just wanted to hear it from someone with a bike sitting there.

[crixal]

we need a ride report asap, lol. how much did you pay? you got the port, cam, and piston, right?

[ml450r]

porting, cams, 13.5-1 piston, pipe, filter and intake.
Porting $450
Cams $625
The custom piston from JE is a true 13.5:1, sells for $260 The pipe is $475 the free air kit, which works way better than any of our other intake kits, is $135

I also have a pc3 not sure if I am going to use it or not. I guess there are alot of bikes with similar mods running just the pink wire cut.

[ltr311]

Im curious to know how this bike runs. Im thinking about a ds for a practice bike and would probably have rossier do some work. I found one with full holz suspension, upgraded carrier and axle and carbon motoworks pipe and programmer for 5k. Its only been ridden a handful of times. Should do just fine for practice.

[TNT]

Originally posted by TNT1
its the factory plug for BUDDS. Make that three cigars. :D


Originally posted by dblbkb
That plug is not for BUDDS, BUDDS is the square plug in the middle that is plugged into a blank.

The conector you are pointing out is not conected to anything. It is just tie wrapped to the side on my bike and every other I have seen.

Not sure what it is intended for only the electrical engineer knows that I guess. Perhaps it is there to add weight! :ermm: :confused: :blah:

So what are you saying I was close but no cigar? :ermm: :confused: :blah:

[dblbkb]

You were close, so one Cigar.

[DS450LOVER]

speed sensor.......