zerk fitting on stock carrier?

[ae13291]

hey guys, i just took my carrier out, and i am about to remove the bearings. does anybody have pics of can tell me where the zerk fitting goes to? i have seen a picture of it on the side of the chain adjusting coller, but does that just squirt into the outer housing? i want it to squirt straight into the bearing area.

[Gibson]

here's where the one on my twin row is, this is the simplest way to do it, but you have to take the rear end apart to grease it. It holds enough grease to last several months though.

http://i276.photobucket.com/albums/kk34/crg10493/100_1043.jpg

[ae13291]

hummm thats pretty cool, but i want one that i will be able to do from the side, i guess i might have to modify something to make it work, but i just want to see a picture of how the ones from the side work, or an explanation of how it greases

[bigredisb]

I think Burgard makes one. You can find them in the sponsor forum.
http://www.burgardcycle.com/xcart/product.php?productid=32&cat=1&page=1

[ae13291]

anybody else?

[billyboy93]

i have a RAD carrier with the fitting on the sprocket side. stock bearings have no way to take in the grease so you have 2 remove the isside seal on the bearing for it to work unless you buy a carrier like the RAD 1

[billyboy93]

rad carrir (http://cgi.ebay.com/ebaymotors/HONDA-400EX,-250R--RAD-BEARING-CARRIER-400-EX-250-R_W0QQitemZ360141785794QQcmdZViewItem)