hotcam

[justen08]

lookin for a hotcam for my outlaw if they make them post a link plz i went to there website and didnt see them for my bike thx

justen

[Colby@C&DRacing]

They make a cam for the KTM motor but it is a top end super moto cam.

[525Outlaw#55]

The hot cam is what I have in mine and colby's right it's a top end cam, you'll lose a little bottom with it, but it definately opens up the top end. Just depends what kind of riding you're doing. I'm racing TT & Supermoto with mine

[justen08]

so if i do some trail riding or sand riding it isnt to good and what mods did you have to do with that cam thx for the replys

[525Outlaw#55]

If you want to open it up on the top end then it's pretty good, I like mine, it wasn't a huge loss in bottom end or anything by no means. I have the hot cam, FMF Factory 4.1 with the power bomb header, jetted the carb, did the water mod and that's it. Tryin to get some money saved up for some serious engine work haha

[justen08]

i hear ya man im tryin to get a lil boost if you have a link to it can you shoot it to me plz i looked on hotcams website didnt see nething i geared it down to with little sproket on front and bigger on back its got alot of low end

[525Outlaw#55]

Well I looked on there and can't find it either. I know they have it, Might have to just give them a call

[justen08]

they want 400 at the dealer for cam and labor does that sound right or is it to much? I asked bout the water mod and he hasnt heard of it.

[525Outlaw#55]

That kinda sounds high to me but then again where I get my stuff done at, I race for and get hooked up on labor, so that might be pretty good pricing then. There's another post on the forum about the water mod, I know colby knows what it is/I'm talking about

[justen08]

yea i have been tryin to search for it

[evil 525]

Hey I have a used one with about an hour and a half for 90$ + shipping. I love my bottom end too much to run it.
Hey what's the water mod?

[Colby@C&DRacing]

http://www.exriders.com/vbb/showthread.php?s=&threadid=374305

Here is the thread

[2-330s]

call munn racing i ordered the ktm supermoto package comes with high comp piston and cam the piston will compensate for the loss of bottom end. it still runs on pump gas. and rips. well i guess it's ported to

[somewon]

Justen,

if your looking for quick and easy power parts for your quad i would not put the cam first on your list. I would make sure you have the big three done first, then if your not satisfied with the results tear into the motor. putting the cam into the KTM motor with nothing else done to it would probably disapoint you as for the cam to get it's full potential the motor still needs to be able to breathe better (intake, exhaust, jetting).

That is all the cam is designed to do, allow the motor to make better use of the air it has available.

[justen08]

yea thanks somone i got my exhaust im workin on the other 2