View Full Version : kfx400 axle prob?
shawn3389
03-18-2009, 07:01 PM
ok so by friend wanted to change his axle bearings and can't get the sprocket hub off....are they all this hard to get apart?
cataway
03-19-2009, 03:32 AM
are you refering to the part were you have to get the 2 jam nuts off?
shawn3389
03-19-2009, 05:15 AM
no they are off, but the hub for the sprocket won't come off...:confused:
jonboy
03-19-2009, 05:16 AM
Take the brake side off its much easier
shawn3389
03-19-2009, 05:34 AM
couldn't get that off either, we took the nut off and it just won't move
quad97
03-20-2009, 12:09 AM
Sprocket hub should just slide off. May be rusted in the splines. Try heating the hub a little and squirting penetrating oil into the splines. I think the brake hub is pressed on and the nut is there for a safety.
shawn3389
03-20-2009, 04:50 AM
ok he is going to heat it tomorrow he has been putting penetrating oil on it for 3 days now....
cataway
03-20-2009, 05:39 AM
heat and a air hammer ,a big one, not one of them cheep ones that ya can get at walmart .
i would be very carefull about swating it with a hammer
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.