steve250r
03-17-2009, 09:27 AM
This front end was Custom made by Bunderson Racing out of Las Vegas. If you’ve never heard of them, they have fabricated quite a few high dollar one off projects. This front end was designed for desert racing and was made very strong. It is +3” wide and uses standard travel front shocks. I used Custom Axis shocks with this set up and it was very smooth. I’ve also got a Laeger Pro Trax T-Pin front end and this will give it a run for it’s money. The spindles are custom made to allow more travel with the use of heim joints rather then ball joints. They also accept the ’86-’87 front hubs. The A-Arms are fully adjustable for camber and caster. The tie rods use heim joints on the ends as well. All bushings and heim joints are in great shape and have a lot of life left in them. A-Arms and tie rods are powder coated silver hammertone and the spindles are powder coated Honda red. I don’t think there is a scratch in the powder coat. This setup was not built by an amateur and was used by a desert racer. I’ve also got a set of Aftermarket aluminum front hubs that are based on the ’86-‘87 brake rotors and bearings. I think they might be Nac’s but I’m not 100% sure. Either way the bearings are in great shape and they work well. I’ll also include the brake rotors. The steering stem is a stock Honda unit that is powder coated silver hammertone to match the a arms. Again the stem is perfectly straight and the powder coating is mint. I’m asking $550. for everything. Will sell parts separately as well. A-Arms, Spindles, and Tie Rods $400. Front Hubs w/ rotors $175. Steering Stem $75. Let me know if you have any questions.