hipers??????

[450Rfutureracer]

Well I have a set of hiper wheels all around for my 450r but I sold it and now they dont fit the new 525. The ones for the back have the same bolt pattern but seem to have too small of a hole. So I am looking to see what everyone else is doing about this. Just wondering what everyone is running for the hipers. I still don't know what offset the stock rims are either. The ones i have are honda 4+5 in the rear and 3+2 in the front. Also I was wondering if anyone is running the rath front hubs to change from ktm to honda. Are they hard to do? Thanks for looking.

[holeshot19]

just get u a set of cf1s i bought a new set of 4 for $460 shipped, the front is 4+1 offset and the rear is 3+6 offset, those hiper tc3 dual rear beadlocks makes the rear too narrow if u run those u need to space out the rear axle the stock spacer makes it too wide u can get a mechine shop to cut the stock spacer but as far as the front hubs i would replace the wheels first

[holeshot19]

my bike

[JM317]

I run 4+1 fronts and 4+5 rears with the axle spaced out. You might need use a round file on the bolt holes to get them to fit. As far as the fronts, you can buy the Yamaha pattern centers and replace your Honda centers.

[quad97]

I had to drill the inserts out one size bigger on my hipers for them to fit on the rear. The hole pattern is correct, but the hole size is not.

[flash]

I run 4+5 offset hipers, cut the spacer myself. I put it in vise and used a hacksaw, looks like factory job, pretty simple.