Is this what i need to rebuild?

[uspatriot]

My 400 has been burning a lot of oil and smoking a lot lately, so i decides i want to do a top end rebuild.

The only things i need are a piston, rings, gaskets/seals correct?

Do i need to hone the cylinder out?

Is this all i need?
piston (http://www.rockymountainatv.com/productDetail.do?navType=type&navTitle=Engine&webTypeId=201&webCatId=17&allVehParts=true&prodFamilyId=3784#vehicleSelect)
gaskets/seals (http://www.rockymountainatv.com/productDetail.do?navType=type&navTitle=Engine&webTypeId=202&webCatId=17&allVehParts=true&prodFamilyId=3146#vehicleSelect)

Dose that come with the valve seals?

[uspatriot]

bump

[dariusld]

If your burning alot of oil, you won't know what shape your cylinder is in, till you take it apart. You might need a bigger piston. You will probably have to bore the cylinder and the machinist should have the piston in hand when that is done.

[matt14c]

You could be burning oil do to the valve seals also.

[rob_990]

id bore it out to a 406 just to be safe.you might want to throw in a new timing chain too

[Snipe]

I would first take it apart and look at what I have. It could be as simple as adjusting the valves to a whole re build. Need to know what ya have before really telling you what you should buy. So strip her down and see how bad it really is.

[Sanddraging28]

when in doubt......tear it done and build a big nasty stroker:devil: :devil: :devil:

than add a shot of nitrous:eek2: :eek2:

[sc400ex_rider]

i recommend factory oil seals the ones in those kits are crap and will go bad in a year or two.