View Full Version : Removing swing arm bolt.
motox92
03-06-2009, 09:29 PM
Ok, I got my whole quad stripped down. Whole front end if off. Now with the rear end...The swing arm bolt will turn freely when i put a socket on the ride side of the bolt(right side sitting on the quad) Now I sprayed it with PB and hit it for about an hour or so and it would not budge!!! Someone have any ideas? I think I might have to heat it up?!?!
shok47
03-06-2009, 09:39 PM
You gatta repeat the same process over and over again; heat, spray, hammer and hope for luck
ngates788
03-07-2009, 12:17 AM
it like h3ll
jcs003
03-07-2009, 12:52 PM
try to find some sort of "puller" to get it started
Swiper77
03-07-2009, 01:03 PM
And start looking for a replacement bolt!
motox92
03-07-2009, 07:43 PM
Yeah lol, I got my bolt out today. Its *uck**
Powered by vBulletin® Version 4.2.1 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.