riderssb250x
02-25-2009, 09:11 AM
im building an 86 r trail quad need some advice on engine
im rebuilding the bottom end found a guy who had a never fired r motor with a short rod im getin the whole crank for 215 so that takes care of the bottom end
bored .60 over wiseco pistin its in good shape im puting in new rings and it should be good I got the topend honed and the cylinders in good shape so I don't need a bore or piston
I have a boyseen rad valve with brand new boyseen reeds to go in, also I got a half inch reed spacer
fmf fatty and powercore 2
what do you guys sugest doin to make it a beter trail motor is this setup pretty good?
im not sure what I have for a carb I will check
what should I do for gearing also?
im lookin for advice like should a run a open box or no box and an outerware?
is it woth geting one of thos rpm adjustable timing things I see them on ebay?
what should I be at for jetting!!! that's a big thing im lookin for help with!
is a cr250 gasket gonna help me out?
guys help me out with advice thanks
im rebuilding the bottom end found a guy who had a never fired r motor with a short rod im getin the whole crank for 215 so that takes care of the bottom end
bored .60 over wiseco pistin its in good shape im puting in new rings and it should be good I got the topend honed and the cylinders in good shape so I don't need a bore or piston
I have a boyseen rad valve with brand new boyseen reeds to go in, also I got a half inch reed spacer
fmf fatty and powercore 2
what do you guys sugest doin to make it a beter trail motor is this setup pretty good?
im not sure what I have for a carb I will check
what should I do for gearing also?
im lookin for advice like should a run a open box or no box and an outerware?
is it woth geting one of thos rpm adjustable timing things I see them on ebay?
what should I be at for jetting!!! that's a big thing im lookin for help with!
is a cr250 gasket gonna help me out?
guys help me out with advice thanks