Brand New Ball Joints, For after market A-arms

[firebug]

I have a brand new set of Rickey Stator (4) ball joints that I bought and do not fit my Lonestars so I need to sell them.

The description from where I bought them:

"The most degrees of angle movement.
16mm threaded shaft. The stud and socket are essentially a copy of the TRX250R's.
The ball has a lot of contact with the socket making for a more distributed load, which results in better wear characteristics.
These Ball Joints have been tested in every long distance race and has won them all!"


$70 shipped

[honda450R2007]

will these fit laeger arms?

[Honda 250r 001]

:eek: :eek: im pretty sure you can get a full set off ebay for less than 50. take any less?

[MX142]

they are 20 a piece i just bought some. but why wont they work on lonestar arms

[firebug]

I payed $90.95 shipped to my door. Im not sure why they wouldn't fit, I was under the impression that they would but they were to big to thread into my a-arms (very old 250r Lonestars) They have a 1.5 thread pitch and a 16mm threaded shaft. I guess find the specs on yours to see if they will match up.

[bbender85]

just some info, i am looking for new ball joints for some old arms i have, and i am pretty sure they need a 14mm shank; i almost made the same mistake you did. fwiw.

[firebug]

http://i124.photobucket.com/albums/p4/TravisC_03/Bikes/DSC02287.jpg

http://i124.photobucket.com/albums/p4/TravisC_03/Bikes/DSC02288.jpg

http://i124.photobucket.com/albums/p4/TravisC_03/Bikes/DSC02295.jpg

[firebug]

Bump


Price now is $55 shipped