Which motor to put in the Blaster frame

[OcTaNe110]

I don't which motor to put in the Blaster frame . I don't know which one is more powerful or faster. Which one is the most difficult to put in the Blaster frame.THanks

Well, what king of riding do you plan on doing, if your gonna drag race it, put a ported CR500 race motor in it.

[mysticfalcon]

id say try the motor from an old IT200 dirtbike. that might work good

[OcTaNe110]

I was thinking maybe a Yz250 or a TRi-z 250 motor I don't know which one to put in there , I doubt that a CR500 motor in a BLaster frame that would vibrate so much I get tired.

[toomeyshee87]

krankenstien!! haha:devil

[Ryan]

Originally posted by toomeyshee87
krankenstien!! haha:devil

haha, you will crack the frame in half taking off with a motor like that ;) . I wouldn't take anything to extreme with a blaster unless you have everything extended like a-arms, axle, swing arm ect. I would go for a dirt bike motor being that they are small, maybe a 125 engine.

[OcTaNe110]

It wouldn't crack becuase imy frame has been reinforced frame. I've seen Blaster with Yz250 engines in them and a CR250 in it didn't crack.

[Ryan]

I know it wouldn't crack I was kidding. I wouldn't put a 250 motor in that though. Try out the 125 and mod it. Trust me thats fast enough.

[Juggalo]

the easiest motor to put in is the DT200 motor. its the motor the blaster is based on but much much better and liquid cooled too i believe. problem is their hard to find in the states. i would put a yzf250 motor in it.

[DaveEX7]

squeeze the YZ250 engine in there

[OcTaNe110]

See I was going to do that because I heard there fast. But the only problem is I can't find a Yz250 motor for sale for real cheap.

[Juggalo]

don't use a YZ motor its not counterbalanced and it will shake the quad apart and snap the frame even if its reinforced. use the YZF motor. it won't be cheap but it'll be worth it.

[OcTaNe110]

If the Yz will shake it that bad and probably crack how about the Tri-z motor .

[Krazy Kid]

dont shake at all but i dunno in a 4 wheeler frame. if thats wut u decide oni got a tri z engine for sale

[OcTaNe110]

I'll probably get it, is it real cheap what is the price . What condition is it in and what do you have done to it.

[honda400exrider]

yeah i think that it would be very wise to make sure that the chasis can handle the new motor that you decide to put in. i would reccomend all the mods... arms, shocks, swingarm, and axle before you put a high horsepower engine in... btw, what made you decide to put the engine in a blaster chasis? just curious...

[OcTaNe110]

I using a Blaster frame becuase it is cheap and the second Lightest frame that I could find that wasn't a LT250R

[honda400exrider]

ooo ok i c...

what are you using it for? (racing, mx, etc)

[OcTaNe110]

I don't know yet something like trail riding and mx . Man I have to get some better shocks there going to be expensive.