dunatic
02-19-2009, 11:45 PM
Looking for someone that is parting out a LT80. I need the following:
1. Where the rear brake cable attaches to the drum lever it goes thru a barrel with an adjuster nut. I need both the barrel and nut.
2. 20mm carb & filter. This is the DG kit that is widely used in a hop up application.
3. James Lucky wide ride kit. These are the a-arm extenders, not the wide lug stud extenders.
4. Stator side vent hose. The one that attaches to the top of the plastic cover.
5. Tranny vent hoses. Both the one that goes to the back of the stator side of the motor and the one that attaches to the front of the clutch cover and goes to the air box.
6. Top of cylinder rubber cap. The spark plug boot does thru it.
7. Pull starter
8. Ignition rectifier. Mounts next to the coil on the frame.
1. Where the rear brake cable attaches to the drum lever it goes thru a barrel with an adjuster nut. I need both the barrel and nut.
2. 20mm carb & filter. This is the DG kit that is widely used in a hop up application.
3. James Lucky wide ride kit. These are the a-arm extenders, not the wide lug stud extenders.
4. Stator side vent hose. The one that attaches to the top of the plastic cover.
5. Tranny vent hoses. Both the one that goes to the back of the stator side of the motor and the one that attaches to the front of the clutch cover and goes to the air box.
6. Top of cylinder rubber cap. The spark plug boot does thru it.
7. Pull starter
8. Ignition rectifier. Mounts next to the coil on the frame.