screach when back brakes used

[crxjarred]

ok when i go to slow down the back break will screach what dose this mean? new brake pads?

[sc400ex_rider]

yep pads wore out, its metal on metal :(

[droppedmazda]

it also could be that the axle bearings are out causing the pads and the rotor to hit at different angles so check and see if the axle has any play in it while your checking the back brakes.

[ThreeDollaBills]

Once mine did that and I had a pebble stuck inside the caliper that was scratching the brake rotor

[crxjarred]

well i have noticed when i pop wheeleies up it turns to the right hard like i can evan ride them long cus ill run into somethen some one told me that it could be the axle bearings so thats 2 things gone wrong that could blame the bearings i need to check them lol witch direction would there be play up down or left right

[billyboy93]

differnt tire pressure in each tire will make u not go stright

[crxjarred]

yea but i checked them and they were the same
and its like prity bad turning

[ThreeDollaBills]

Sounds to me like your brake is rubbing to rotor, or your bearing is bad. Ride for like 5 minutes and then put your hand on the barring carrier. See how hot it is.

[droppedmazda]

if it has any play in it, it will move up and down prolly. just put the quad on something where the back wheels will be off the ground. grab the axle and see if it moves at all, if it moves, it prolly needs bearings.

[crxjarred]

ok well i went out there and started to take off the parking break im guna make my own block of plate and im guna check the axle and see if its got any play and the break pads my fingers just got to numb to work anymore its cold out