PowerCommander Question

[ltrwang]

I have a 2008 LTR LE. I am currently running a Full Rossier system which only requires a the cherry bomb and air box lid removed. Per the install directions with the pipe, if I go with any further aftermarket intake I will need a fuel controller because the cherry bomb isn't enough. This leads me to my question.

I am looking at getting the Fuel ATV air box eliminator and a PowerCommander. In researching powercommanders website, I do not see a map for the setup I am looking to run. Will the bike then have to be taken to a dyno shop which tweaks powercommanders, or are other maps out there which I have not come across? Thanks in advance.

[bosshogg1]

I want to run the fuel atv set-up to.I have the yoshi rs-5 slip-on,stage 2 hotcam intake,new timing chain,port/polish,new vavles,bored 2-3mm over,an the trinity pc, I was wondering if this was to much or would I need more stuff to keep it running right an should I get a aftermarket rev box

[hondaracer31]

I'm pretty sure Fuel has PC maps for his set-ups.