axle bearings

[LONG-ROD]

I need to replace the rear bearings in my bros bike. the bearing carrier ha no name itdoes have a zert and i am pretty sure the swinger is an older leagers so how do i no what bearings to order are they all the same

[deathman53]

you will have to remove the carrier to tell, it can be a single bearing, dual row or tapered. A single row will be ~13mm, dual row ~20mm and if its tapered it will be in a cone shape and have a cup tapered cup inside of the carrier. You more than likely have a dual row carrier, I don't think any of the aftermarkets sell a single row carrier, its either dual row or tapered. Yes, most of the dual row bearings are the same for alot of bikes.

[LONG-ROD]

I have it out and I took the bearings out there was one on each side does that help

[05LSR250R]

Single row carrier just like stock. How thick are the brgs about?

[LONG-ROD]

oh I would say 1/2 inch max

[05LSR250R]

Single row bearing carrier same as stock. Some kits come with the center crush tube which is a plus.

[deathman53]

if its 1/2" max, thats almost equal to 13mm and that would be a single row bearing(stock).

[atvfreak400]

I pulled mine apart and it had 4 single 12mm bearings in it 2 on each side anyone seen that before

[05LSR250R]

Thats a dual row carrier. Same as stock except it has four bearings. Same size as stock on the bearings and seals.