help on which wire to cut for more rpm

[Checkedout222]

i need help on which wires to cut to get more rpm on the rev box does anyone know wut 2 wires ??

[d3ktrix]

Here ya go steve.

[HoleshotR15]

IS this SAFE? What would be the downfall to this?

[jkiserracing]

you do this on aftermarket cdi's too??

[d3ktrix]

Originally posted by HoleshotR15
IS this SAFE? What would be the downfall to this?

Its safe as the engine will still run correctly, its the same thing the Honda HRC kit harness does.
But of course there is always a risk associated with revving an engine higher.


Originally posted by jkiserracing
you do this on aftermarket cdi's too??

No

[jkizz18]

actually u lose power if u dont have a cam or any substantial mods. its proven on the dyno but feel free to argue it. :devil:

[HoleshotR15]

Ohh B/c i was going to do it, I wont bother now, I only have an exhaust, motor itself is stock.
Any curve change or just higher rev?

[jkizz18]

its only supposed to give u higher rpms. but it does change the curve as well. u can pull the pin like i did instead of cutting the wire. that way u can put it back the way it was easy if u dont like it

Originally posted by jkizz18
actually u lose power if u dont have a cam or any substantial mods. its proven on the dyno but feel free to argue it. :devil:

I dont think you loose power, if your going past the stock rev limiter your just not making as much power but its already there so its not decresing power.

[hendershot106]

Originally posted by jkizz18
actually u lose power if u dont have a cam or any substantial mods. its proven on the dyno but feel free to argue it. :devil:

post the dyno result to prove this ....