parting out 400ex build that never got finished

[jhtrx250r]

I was going to build a 400ex/250r hybrid
so I am going to part it out
all parts look new and have either been powed coated or repainted:
Main Frame (RED powder coat) bare performance gusset kit installed
$200

stock 04 parts: front spindles set $45, hubs new bearings and red paint set $40, calipers almost new pads set $100,rear swing arm looks new good bearings $125, take off rear carrier still looks new $85

after market:burguard chrome +2 a arms set with tie rods good ball joints and bushings $220
galfer +3 steel braided brake lines $35
works steelers tripple rate nice $190

some other stuff I still need to go through.

[jhtrx250r]

pics

[jhtrx250r]

pics

[jhtrx250r]

some more pics

[jhtrx250r]

hub pics

[jhtrx250r]

calipers

[sc400ex_rider]

does this have a full bear gusset set installed. if so can you post more pics of all or any of the gusset points. thx

[jhtrx250r]

Yes it is installed, the two tubes on the top buy the steering mount can be seen in the first pic, I will try to send a few more

[jhtrx250r]

more

[jhtrx250r]

If you want it let me know I will try to get you a shipping Quote

[sc400ex_rider]

thx JH, that frame is sweet and a deal for $200. your basically paying for the gusset kit and powder coat and getting the frame for FREE.

[jhtrx250r]

I paid $500 for it this way so yeah its agood deal when you price out gusset kit install,sand blasting and powder coating, shipping would proubly be around $80 thats the down side

[pdxbigfoot]

I need to look at your EX spindles. If they are in better shape than mine i need them. Give me a call when you can...Later
Jason