300ex/350x conversions probs please help

[TRX_Thumper]

ok i finally got my top end together and the motor bolted in....first of all...the front sprocket comes nowhere near lining up...im using a 300ex carb...its not long enough...between the motor an intake from the airbox...neither is the stock 350x carb..and what clutch cable should i use? stock 300ex is just to long....

[TRX_Thumper]

common i need some help...if i get some suggestions....then yall can look at the pictures...ill post em:D

[toby400ex]

i dont any info on the sprocket prob , but i think people usually use a 400ex carb and a 350x airboot, i dont see how the cable being to long would be a prob.

[joeroadking]

use 350x carb+ boot as well as 300ex boot cut both boots and put a section of pipe inside them with two hose clamps between with hose clamps rear sproket need to be shimed out simple just put washers between hub and rear sproket slide bolts back through to acheive proper alignment !