a-arm bushings

[UglyMotha™]

hey how do you guys go about removing those compression clips inside the a-arms thats holding the bushings in i tried a little bit of everything tonight and just couldn't get underneath of them to pop em out, i'm sure there's and easy way of doing it but i haven't got my service manual yet so it's not like i can check it there so this is the next best thing for now

thanks, Ugly

i asked this question back when i had to change mine and got very few replies. but i did it and got it so ill let u know what i used and what works the best. Go out and buy a flathead screwdriver that is made for eyeglasses screws. It is the only thing small enough i have found to get in there. Then when u lift up the clip you need to have tweezers to pull it out. With this method i changed all the bearing in a little less then 2 hours. The first hour was trying to figure out how to get off the clips and everything takes me very long lol