What kind of pipe is this?

[Yee-Haw_400EX]

Is this an ESR? I'm only guessing because of the sticker on the shroud.

[1promodfan]

I might be wrong, but I don't think thats a ESR. I'm not sure what it is though.

[chadbarger18]

from what ive seen it looks like a paul turner mid but dont hold me to that im not familure to 250r's

[trx250r 88]

maybe dyno port

[rustyATV]

Originally posted by chadbarger18
from what ive seen it looks like a paul turner mid but dont hold me to that im not familure to 250r's

Unless it's a VERY early one, I don't think it's a PT; they're much better put together and normally have an ID plate welded to them.

[Michael88R]

Looks like a CPI pipe to me.

[dunatic]

Unless Mike Hare at CPI got off his lazy butt and actually did some work, that is not a CPI pipe.

Take a look at CPI pipes, they don't have half that many cuts and welds. that pipe was designed to clear the kicker, so id say it was built for FT or TT racing.

Actually is looks a lot like a KLEM research pipe that I used to have. Just a lot larger mid section.

Thats a REV pipe for sure

[mizzoufan]

Maybe a CT pipe. I have a buddy with one on a tecate 4. Looks very similar. They welds, and the chrome. Looks like a good pipe.

[dunatic]

now a CT pipe I would agree with.

[Michael88R]

It kinda looks like this one which I'm pretty sure is a CPI.

[dunatic]

Originally posted by Michael88R
It kinda looks like this one which I'm pretty sure is a CPI.

that is a cpi....u can see the pipe is stamped, but has one less cut and bend in it.....like i said, mike doesnt work that hard

[derby]

That is a cpi, most of them were built for the packard rotax motors. I guess packard has some pull with cpi since those are the only pipes he uses? That appears to be a hand built pipe on the stamped style like nearly all cpi pipes.

[sandspanker]

:) That for sure is a CPI pipe. A lot of my friends have them and none of them look the same. :)