XFR Grab Bar pic

[NSTIG8R]

Need a pic of an XFR rear Grab Bar installed.

Thx
Mike

[3400ben]

Are you having problems installing?

[NSTIG8R]

yes, I haven't seen one installed.
I am assuming you do not have to cut the OEM G-Bar Off
but that's where I could be wrong.

[3400ben]

I cut the oem bar off flush with the frame. If you go to the hardware you can get plastic plugs that slip right in the frame. You have to shim pipe to keep it from hitting the frame. I have slow dial up or I would post a pic.

[Logan #34's Dad]

NSTIG8R, Before you cut the factory grab bar off please check the rules. With the new rule about the pipe not being aloud to extend past the grab bar and be under the grab bar they may frown on a bolt on grab bar. In other words, If my MK pro-pipe silencer is too long (which it is) then what's to stop me from bolting on a longer grab bar to make it legal. Just a thought.

[hotquads1]

ROCKY IS RIGHT , TECHNALLY SPEAKING THE atva RULES state , material may be added for strength but frame cannot otherwise be modified nor material removed . this is up for questioning if you were ever protested.
marc

[NSTIG8R]

Thanks Guys, We run mostly XC so it shouldn't ba an issue but is good to know.

The OEM pipe on the DRX50 extends several inches past the grab bar. How do they handle that?

[hotquads1]

the 2" snout on the back of the silencer will have to be cut off , to be legal .
marc